series 107-50 inserter - extractor ("ultra strong") CORPORATION 4915 Walnut Grove Ave. San Gabriel, CA 91776 Tel. 626-287-0451 Fax 626-287-7350 Website: http://www.calmark.com E-mail: sales@calmark.com tech@calmark.com Calmark offers the Series 107-50 Card Inserter-Extractor for safe and easy insertion and extraction of PC cards in the severest applications of high insertion and extraction forces. FEATURES: * "Ultra strong" lever action design overcomes insertion and extraction forces of highest possible limits. * Narrow width -- .290 inches (7.37). * Actuates from a simple "U" channel form. * Mounting detail on card retrofits other industry standards. * No chamfer required on corner of card. MATERIALS & FINISH Extractor - TABULATION Aluminum alloy 6061-T6. Black Anodize per MIL-A-8625, Type II, Class 2. For Conductive Finish, add prefix "C" to part number (C107-50). Clear chemical film per MIL-5541, Cl 3. Roll Pin: Stainless Steel, 3/32" (2.38)dia. x 1/4" (6.4) long. Furnished with each inserter-extractor. For Pre-Started Assembly Pin, add prefix "P" to part number (P107-50) TOLERANCES: .xxx = +/- .010, .xx = +/- .02 (.xx=+/- 0.25, .x=+/- 0.5) PART NO. Card Thickness 107-50 1/16" (1.6) 107-50-3 3/32" (2.4) 107-50-4 1/8" (3.2) .109 Dia. Hole (2.77) APPLICATION DATA: Two inserter-extractors are required per board. Provides insertion and extraction travel of .35(8.9) minmum with a mechanical advantage of approximately 4.5 : 1. .500 (12.70) .250 (6.35) .156 R (3.96) Assembly Pin (furnished) .290 (7.37) .250 (6.35) 2.00 (50.8) Nominal position of card edge when seated in connector. The Inserter-Extractor will allow .05 (1.3) over-travel for tolerance take-up. .285 +/- .015 (7.24 +/- 0.38) .475 (12.06) Card Guide Surface .73 (18.5) 0.06 Ref. (1.5) .36 (9.1) DETAIL OF ACTUATING SURFACES Required on top and bottom guide plates of Calmark fabricated card cages. 58 Unit: INCH (MM) .06 Max. (1.5) .24 Min. (6.1) Card Clearance required when rotated.