ZSR
SERIES
ABSOLUTE MAXIMUM RATING
Input voltage 20V
Output Current(Io) 200mA
Operating Temperature -55 to 125°C
Storage Temperature -65 to 150°C
ELECTRICAL CHARACTERISTICS
Notes:
1. The maximum operating input voltage and output
current of the device will be governed by the
maximum power dissipation of the selected package.
Maximum package power dissipation is specified at
25 °C and must be linearly derated to zero at
Tamb=125°C.
2. The following data represents pulse test conditions
with junction temperatures as indicated at the
initiation of the test. Continuous operation of the
devices with the stated conditions might exceed the
power dissipation limits of the chosen package.
Power Dissipation (Tamb=25°C)
SOT223 2W(Note 3)
TO92 600mW
S08 780mW(Note 3)
3. Maximum power dissipation, for the SOT223 and
SO8 packages, is calculated assuming that the device
is mounted on a PCB measuring 2 inches square.
4. The shut down feature of the device operates if its
temperature exceeds its design limit as might occur
during external faults, short circuits etc. If the
regulator is supplied from an inductive source then a
large voltage transient, on the regulator input, can
result should the shut down circuit operate. It is
advised that a capacitor (1µF or greater) should be
applied across the regulator input to ensure that the
maximum voltage rating of the device is not
exceeded under shutdown conditions.
ISSUE 3 - SEPTEMBER 2001
2
SYMBOL PARAMETER CONDITIONS MIN. TYP. MAX. UNITS
VOOutput Voltage 2.78 2.85 2.92 V
IO=1 to 200mA τ2.736 2.964 V
Vin=4.85 to 20V
IO=1 to 100mA τ2.736 2.964 V
∆VOLine Regulation Vin=4.85 to 20V 10 40 mV
∆VOLoad Regulation IO=1 to 200mA
IO=1 to 100mA 5
225 mV
mV
lqQuiescent Current τ350 600 µA
∆lqQuiescent Current
Change IO=1 to 200mA
Vin=4.85 to 20V 100
100 µA
µA
VnOutput Noise Voltage f=10Hz to 10kHz 75 µVrms
∆Vin /∆VORipple Rejection Vin=5.85 to 18V
f=120Hz 48 62 dB
Vin Input Voltage Required
To Maintain Regulation 4.85 4.55 V
∆VO/∆TAverage Temperature
Coefficient of VO
IO=5.0mA τ0.1 mV/°C
ZSR285 TEST CONDITIONS (Unless otherwise stated):Tj=25°C, IO=100mA, Vin=6.85V
=Tj=-55 to 125°C