LPV-60-15 - MEAN WELL ENTERPRISES

SPECIFICATION

MODEL LPV-60-5 LPV-60-12 LPV-60-15 LPV-60-24 LPV-60-36 LPV-60-48

DCVOLTAGE

RATEDCURRENT

CURRENTRANGE

RATEDPOWER

OUTPUT

LINEREGULATION

LOADREGULATION

SETUP,RISETIME Note.6

HOLDUP TIME(Typ.)

VOLTAGERANGE Note.4

FREQUENCY RANGE

EFFICIENCY (Typ.)

ACCURRENT (Typ.)

INPUT

INRUSHCURRENT(max.)

LEAKAGECURRENT

SAFETY STANDARDS

WORKINGTEMP.

WORKINGHUMIDITY

STORAGETEMP.,HUMIDITY

TEMP.COEFFICIENT

VIBRATION

MTBF

DIMENSIONOTHERS

NOTE

PACKING

OVERLOAD

OVERVOLTAGE

5V 12V 15V 24V 36V 48V

8A 5A 4A 2.5A 1.67A 1.25A

0~8A 0~5A 0~4A 0~2.5A 0~1.67A 0~1.25A

40W 60W 60W 60W 60W 60W

80mVp-p 120mVp-p 120mVp-p 150mVp-p 150mVp-p 150mVp-p

¡Ó

8.0%

¡Ó

1.0%

¡Ó

6.0%

90~264VAC 127~370VDC

47~63Hz

76% 83%

¡Ó

2.0%

¡Ó

5.0%

83% 86% 86% 86%

5.75~6.75V 13.8~16.2V 17.25~20.25V 27.6~32.4V 41.4~48.6V 55.2~64.8V

1.2A/115VAC1A/230VAC

0.25mA /240VAC

110~150%ratedoutputpower

Protectiontype:Hiccupmode,recoversautomaticallyafterfaultconditionisremoved

CompliancetoEN55022(CISPR22)ClassB, EN61000-3-2Class A,EN61000-3-3

CompliancetoEN61000-4-2,3,4,5,6,8,11,EN55024,lightindustrylevel,criteria A

-30~+70

¢J

(Referto"DeratingCurve")

20~90%RH non-condensing

-40~+80 ,10~95%RH

¢J

¡Ó ¢J ¢J

0.03%/ (0~50 )

10~500Hz,2G10min./1cycle,periodfor 60min.eachalongX, Y,Zaxes

732Khrsmin.MIL-HDBK-217F(25 )

¢J

162.5*42.5*32mm(L*W*H)

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance : includes set up tolerance, line regulation and load regulation.

4. Derating may be needed under low input voltage. Please check the static characteristics for more details.

5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the

complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.

6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.

7. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.

8. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.

¢J

0.4Kg;32pcs/13.8Kg/0.56CUFT

Protectiontype:Shutdowno/pvoltage,re-powerontorecover

60WSingleOutputSwitchingPowerSupply

¡½

Features :

LPV-60 serie s

RIPPLE&NOISE(max.) Note.2

VOLTAGETOLERANCE Note.3

ENVIRONMENT

SAFETY &

EMC

PROTECTION

WITHSTANDVOLTAGE

ISOLATIONRESISTANCE

I/P-O/P:3KVAC

UL879(exceptforLPV-60-5),UL1310(exceptforLPV-60-5),CSA C22.2No.207-M89(exceptforLPV-60-5,LPV-60-48),

CAN/CSA C22.2No.223-M91(exceptforLPV-60-5,LPV-60-48),IP67approved;designreferto TUVEN60950-1

I/P-O/P:>100MOhms/500VDC/25 /70%RH

¢J

FileName:LPV-60-SPEC 2012-12-26

¡E

Constant voltage design

Universal AC input / Full range

Withstand 300VAC surge input for 5 seconds

Protections: Short circuit / Overload / Over voltage

Cooling by free air convection

Fully encapsulated with IP67 level

Class 2 power unit

ass LPS

Suitable for LED lighting and moving sign applications

100% full load burn-in test

Low cost, high reliability

2 years warranty

¡E

¢º

(Note.8)

Fully isolated plastic case

Class power unit, no FG

(Note.7)

500ms,20ms/230VAC5 atfullload ;00ms,20ms/115VAC (for5~36V)500ms,30ms/230VAC500ms,30ms/115VACatfullload(for48V)

50ms/230VAC16ms/115VACatfullload

( for 48V only) ( except for 5V,48V )

EMCIMMUNITY

EMCEMISSION

IP67

LPS

COLDSTART 60A(t =525smeasuredat50%I )at230VACwidth peak

£g